Speck-electronics EQ16 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Audio Speck-electronics EQ16. Speck Electronics EQ16 User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - MODEL EQ16

MODEL EQ16 16 CHANNEL - 3 BAND PARAMETRIC EQUALIZER  Model EQ16-16  Model EQ16-32 Reference Manual speckelectronics

Strany 2 - Edition

Merely affixing the Model EQ16 into an equipment rack is no guarantee that the product is making a reliable ground connection. The mounting rails in

Strany 3 - Contents

7 The following information should give you the basics on how to install the Model EQ16 and Power Supply. The proper installation of the Model EQ

Strany 4 - Chapter 5 Wiring and Other

The PS3 offers a variety of mounting options. The power supply may be placed on any flat surface, permanently affixed to a flat surface, or mounted o

Strany 5 - Introduction

There are 5 terminals available on the power transformer of the power supply. The configuration of the five terminals determine the operating voltage

Strany 6 - Figure 1b. Rear Panel Layout

Next, fit the square plug into the connector at the rear of the Model EQ16. These connectors are also keyed to fit in only one direction. Once the p

Strany 7 - Standard Accessories

Interfacing the Model EQ16 Equalizer To clean the front or rear panel, wipe the surface gently using a soft lint-free cloth to avoid scratching the pa

Strany 8 - Rack mount adapters

Due to the flexibility of the Model EQ16, there are many places it may be interfaced - too many to enumerate in the manual. A basic rule to follow wh

Strany 9 - Initial Preparation

A few of the larger recording consoles that lack a patchbay may use two jacks for the channel's insert points; one jack for insert output, and an

Strany 10 - Shipment

There are no special requirements for installation and interface of the EQ16 to the Xtramix except to use reasonable care in the layout of the audio w

Strany 11 - Installation

15 Figure 6. Speck Xtramix - Application #1 Chapter 3 Installation Section

Strany 12 - Configuring the AC

Speck Electronics makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability

Strany 13 - Power Supply

16 Figure 7. Speck Xtramix - Application #2 Chapter 3 Installation Section

Strany 14 - Rack Mount Adapters

17 We hope to give you basic information on the operation of the Model EQ16 and adequately describe its controls, switches, and connectors.

Strany 15 - Cleaning

The Model EQ16 utilizes 2 of the previously mentioned parametric controls; the frequency select control and boost/cut control. These controls are equ

Strany 16 - Model EQ16 to a Mixer

19 Figure 10. Equalizer Channel Chapter 4 Operation Section

Strany 17

Bandwidth (Q) The bandwidth of the selected frequency is automatically adjusted with the selection of the frequency sweep control. The lowest setting

Strany 18 - Interface to

3. Mid boost/cut 6. Low frequency sweep 4. Mid frequency sweep 5. Low boost/cut As long as you don't dramatically change the sound of the low fr

Strany 19

22 Figure 11. Equalizer Rear Panel Chapter 4 Operation Section

Strany 20

The Model EQ16 is available in two versions: The EQ16-16; 16 mono channels, and the EQ16-32; 16 stereo channels Each channel of the EQ16-16 has two j

Strany 21 - Operation

When using the EQ16 it is important to understand the relationship between the maximum input level, the maximum output level, and the boost/cut contr

Strany 22 - FRONT PANEL CONTROLS

If the headroom is exceeded, it will be necessary to either reduce the amount of "boost" and/or reduce the input level. Reducing the level

Strany 23 - Figure 10. Equalizer Channel

iii General ... Operator Safety Summary ...

Strany 24

26 It is assumed that in addition to the Model EQ16, a considerable investment has been made in electronic equipment such as a mixer, synthesizer

Strany 25

All wire and cable interfaced to the EQ16 and Speck products should be terminated with high quality connectors. A 1/4" plug or XL connector shou

Strany 26

Clock noise is one of the greatest enemies of the audio racks AC system. If a synth or any microprocessor based device emits or somehow couples its c

Strany 27 - REAR PANEL

If a patchbay is utilized in your mixing system, the rules for shielding change. With a patchbay, normally all shields are connected at the patchbay

Strany 28 - Boost/Cut

Installation ... Default Control Settings ...

Strany 29

1 Thank you for purchasing our Model EQ16 Sixteen Channel Equalizer. This manual covers the operation of the Model EQ16-16 and Model EQ16-32.

Strany 30 - Wiring and Other

Figure 1b. Rear Panel Layout 2 Figure 1a. Front Panel Layout Chapter 1 Introduction Section

Strany 31 - Proper AC Grounding

To avoid personal injury, do not remove the top cover from the power supply, or the rear panel of the Model EQ16 and never operate the external power

Strany 32 - Grounding

The Model EQ16 is supplied with a set of rack mount adapters. If the intention is to mount the EQ16 in a standard 19"

Strany 33 - EMI and RFI

5 The Model EQ16 is delivered in a special, protective container and was carefully inspected both mechanically and electrically before shipment.

Komentáře k této Příručce

Žádné komentáře